Common faults and specific solutions of carving machine tools
Source：本站Time：2019/1/18 9:09:58
& nbsp; The problem with the carving machine itself: if a component on the machine is faulty or loose, or if there are impurities on the surface, it may also exhibit misalignment; If the carving machine manufacturer finds that the coupling is loose or broken, it will show misalignment; Long term lack of cleaning and oiling on guide rails and screw rods can also result in misalignment; If the carving machine tool line is broken, it will also exhibit misalignment. The carving machine manufacturer found poor contact between the connecting control lines of various parts (control line transmission line). Solution: Remove all connections and reinstall them.
& nbsp; Carving machine manufacturers customize the production of CNC carving machines, laser carving machines, woodworking carving machines, stone carving machines, advertising carving machines, mold carving machines, 3D carving machines and other equipment. Carving machine is an important production tool for wood processing, and production capacity is very important. During the carving process, carving machines may exhibit various misalignment issues, such as left and right misalignment, up and down misalignment, x-axis misalignment, z-axis misalignment, etc. What are the reasons that cause woodworking carving machines to exhibit misalignment?
& nbsp; The problem with the engraving machine driver: The layout or electronic equipment inside the driver itself can also cause misalignment, which is the most common reason; If the number of times it is presented is not many and the speed is reduced slightly, sometimes it can be carved normally, which indicates that the drive has not completely broken down; If it is misaligned at the beginning of carving, it means that the drive is completely broken. Solution: Repair or replace the driver& nbsp;
& nbsp; Is there any poor contact on the line connecting the carving machine crossbeam to the machine control box and the drag chain; Voltage issue: The engraving machine requires a large amount of power during operation. If the voltage is too low, there will be a lack of power supply to the driver, and the power cannot be reached, resulting in misalignment. This situation is usually characterized by y-axis misalignment, which may be due to poor external voltage or the use of high-power equipment such as welding on the same circuit. Solution: Install a 5000 watt stabilized power supply, but the error margin of this stabilized power supply should not exceed 5%, preferably within 3%.
& nbsp; Problem with interface board, motherboard, and adapter board: If the interface board, motherboard, or adapter board is damaged, the woodworking carving machine may not move in any direction or three axes during operation, resulting in carving misalignment. The problem with the spindle motor: If it is a problem with the stepper motor or servo motor, the entire machine will not move in a certain direction, and the screw cannot be rotated by hand.
& nbsp;